拉拔

汉英

网络释义

na.
1.
【冶】draft; drawing

例句

释义:
全部全部,drawingdrawing,draw outdraw out,pull-outpull-out,Wire DrawingWire Drawing
类别:全部全部,口语口语,书面语书面语,标题标题,技术技术
来源:全部全部,字典字典,网络网络
难度:全部全部,简单简单,中等中等,难难
1.
The elastic deformation of drawing die is an important factor which can affect the accuracy, but it is often neglected in draw forming.
拉拔模的弹性变形是影响拉拔精度的重要因素，但往往在拉拔成形中被忽略。
www.ceps.com.tw
2.
You will actually feel various energy sensations like: tingling, heat, cold, heaviness , and a drawing feeling, to name a few.
你实际上将会感觉各种各样的能量感觉就像：麻刺感、热、冷、沉重和一种拉拔的感觉，可说出来一部分。
dictsearch.appspot.com
3.
This investigation proves that the designed tester can be applied to single fiber pull-out test effectively; and the test results are exact.
结果表明，设计的试验装置和试验方法能较好地进行单根纤维的拉拔试验，具有较高的准确性和精度。
www.ceps.com.tw
4.
It computes the best optimal to minimize the drawing stress with a same ratio of section reduction and Lagrange multiplier.
在保证拉拔过程中应力达到最小，拉拔道次和各截面缩减率一定的情况下，获得最优几何半角。
stae.com.cn
5.
and processing a tubing rolled out from the exit of the three-roller planetary rolling machine into a finished product by drawing.
从三辊行星轧机的出口处轧出的管材通过拉拔加工成成品。
ip.com
6.
Therefore, for estimating strength of the new concrete construction, pull-out test has the potential to be used in practice.
因此对于新建工程之混凝土强度评估，拉拔试验将是具有推广潜力的检测技术。
www.cyut.edu.tw
7.
With good strength and toughness , it is mainly used for drawing dies for drawing tubes and rods .
具有优良的强度和韧性，主要用于制作管、棒拉拔用的拉制模具。
www.mcyber.space
8.
U, I or H sections, not further worked than hot- rolled, hot-drawn or extruded, of a height of less than 80mm.
槽钢、工字钢及H型钢，除热轧、热拉拔或热挤压外未经进一步加工，截面高度低于80毫米。
www.ec365day.com
9.
Straight-line drawbench is the equipment of metal-wire drawing. Its structure is large and its control requirements are complex.
直线式拉丝机是金属丝拉拔的生产设备，其结构庞大、控制要求复杂。
www.chemyq.com
10.
Drawing die cores, wear parts for the textile industry, sealing rings, centerless rulers, drill bushings, valve parts, calibration rings.
拉拔模芯、纺织工业中的耐磨件、密封环、无中心的尺、钻床轴套、阀门、刻度环。
www.showxiu.com