Composite decking question - Woodworking Talk
2021年5月23日 · Probably not the right place to ask this but I couldn't find one for composite decking finishing. My decking has been installed for 10-15 years. It is holding up very well. I pressure wash it yearly and it cleans up nicely. My question is, when it is clean and wet it has a nice color to it, sort of a light brown.
plywood sizing - Woodworking Talk
2023年10月11日 · Model Number: 1252006 Menards ® SKU: 1252006 This is a Meranti/Okumi plywood from Menards that is just about flawless and relatively cheap but how they call it 1/4" is beyond me. (I wish it was marine for the price). I use it for boat frame templates . Actual size listed at .185 " ( mikes at .192" ) 3/16" is .187"
Deck stain over pre finished lumber | Woodworking Talk
2023年7月16日 · I’m building a pretty extensive porch floor using 2x6 lumber that has a lot of picture framing and a simple inlay in the middle (hopefully). I’d like to use the cedar tone pre finished lumber from Menards for the picture frames and parts of the inlay.
Router Table Setup - Woodworking Talk
2024年12月11日 · I need a tip. I am trying to use this box joint jig and I am struggling with getting the correct width. I used a setup block to gauge the distance from the bit, but because the bit is circular in nature but not an actual circle, it barely helps because I don't really know if I am touching the nearest edge of the cutting radius.
Menards MDO handi panel - Woodworking Talk
2021年5月20日 · not sure what grade of MDO Menards carries. just like plywood, it is buyer beware (and cautious). treat the edges by pressing exterior latex siliconized caulk deep into the wood. (or epoxy, if you want to). or even TiteBond Ultra III. the edges of MDO is very sharp when cut - this knife edge must be eased over for proper paint adhesion.
Best outdoor finish for Ipe - Woodworking Talk
2024年8月16日 · The linseed oil once dried isn't a problem. What is the problem is the wood has a lot of natural oils in it like teak does.
What is the difference between standard, quality, and...
2017年2月7日 · I have Menards, HD and Lowe's by me. I have a different grading system from bottom to best grades: Menards- 1. knotty and bowed not suitable to burn 2. Not as knotty twisted and cracked 3. Few knots but strategical placed and sized to give the board no strength and cracks at the ends at least a foot down HD 1.
Cheap? setup blocks - Woodworking Talk
2022年9月29日 · Here's an instance where my machinist 1/2/3 ( I actually made then 4") came in handy. I had my boat frames glued together and gusseted and then needed to transfer my chine notches to the frame.
New Zealand Pine - Woodworking Talk
2022年11月13日 · I first saw it a a year+ ago in my local BBS (Menards) and it seemed a bit strange living in pine-a-plenty MN that the majority of the "Select" (most expensive) pine boards were marked as originating from New Zealand.
15 gauge for a small wooden deck? - Woodworking Talk
2013年9月1日 · As for nails.. at least 16d galvanized for the framing & 8d galv. for the decking. Or 3" & 2" galv screws.. Good luck.. it looks like a cool project and DO take some fotos to share.