Chapter 2B - MUTCD 2009 Edition - FHWA - Transportation
10 Figure 2A-3 shows examples of some typical placements of STOP signs and YIELD signs. 11 Section 2A.16 contains additional information about separate and combined mounting of other signs with STOP or YIELD signs. Guidance: 12 Stop lines that are used to supplement a STOP sign should be located as described in Section 3B.16.
FHWA - MUTCD - 2003 Edition Revision 1 Chapter 2B - Transportation
Stop lines, when used to supplement a STOP sign, should be located at the point where the road user should stop (see Section 3B.16). If only one STOP sign is installed on an approach, the STOP sign should not be placed on the far side of the intersection.
Chapter 2C - MUTCD 2009 Edition - FHWA - Transportation
Table 2C-4 is provided as an aid for determining warning sign location. The distances shown in Table 2C-4 can be adjusted for roadway features, other signing, and to improve visibility.
Stop Sign MUTCD Regulations - Universal Signs & Accessories
Aug 13, 2021 · MUTCD stands for “Manual on Uniform Traffic Control Devices,” and this manual has specific regulations for Stop Sign sizes and placement that must be followed. Stop Signs (MUTCD Code R1-1) are octagon-shaped, red regulatory signs that are used to indicate to drivers that coming to a slow roll is not sufficient, they are required to stop completely.
When a sign is used to indicate that traffic is always required to stop, a STOP (R1-1) sign (see Figure 2B-1) shall be used. The STOP sign shall be an octagon with a white legend and border on a red background.
Appendix B: 2009 MUTCD Standards for Traffic Control Devices
MUTCD Roadside Placement (MUTCD Figure 2A-2) For a typical rural road with no shoulder, the sign should be placed on the right-hand side of the roadway, 12 feet laterally from the edge of the traveled way. In terms of vertical height, the bottom of the sign should be installed at least 5 feet above the ground elevation at the edge of pavement.
Install the STOP sign on the near side of the intersection on the right-hand side of the approach to which it applies, as detailed in the MUTCD. STOP signs are not to be used as a speed control or trafic calming device.
The Manual on Uniform Traffic Control Devices (MUTCD) is approved by the Federal Highway Administrator as the National Standard in accordance with Title 23 U.S. Code, Sections 109(d), 114(a), 217, 315, and 402(a), 23 CFR 655, and 49 CFR 1.48(b)(8), 1.48(b)(33), and 1.48(c)(2).
MUTCD standards is critical. As traffic volume and roadway conditions change, agencies must continually reassess their roadways and work zones to ensure proper design and placement of traffic control devices. Let's review the contents of the MUTCD and learn how agencies use the manual to make decisions about traffic control devices.
MUTCD Stop Signs FAQ - Traffic Sign
The full MUTCD specification is: the minimum height, measured vertically from the bottom of the sign to the top of the curb, or in the absence of curb, measured vertically from the bottom of the sign to the elevation of the near edge of the traveled way, of signs installed at the side of the road where the view of the sign might be obstructed ...