Installing an Instant Hot Water Dispenser - InSinkErator
10. Install the gasket and rings. Now you can plug in the tank. It will take 10 to 15 minutes for the water to reach its target temperature. YOU MAY EXPERIENCE SOME WATER DRIPPING FROM THE FAUCET DURING THE FIRST HEATING CYCLE. THIS IS NORMAL. SIMPLY TURN ON THE HOT WATER FOR 15 SECONDS AND ALLOW TO REHEAT.
No Hot Water - InSinkErator
Upon initial install, the hot water tank takes about 15 minutes to reach target temperature. If you have set the thermostat to your desired temperature, allowed time, and still have no hot water, there are a couple of things you can check.
Water Too Hot or Not Hot Enough - InSinkErator
Locate the thermostat dial on the front of the tank and gradually turn it counterclockwise to decrease the temperature or clockwise to increase the temperature. If the water is too hot, depress or twist the dispenser handle for 20 seconds to allow cold water to enter the tank and allow the water to reheat to the new setting.
Water Taste or Odor - InSinkErator
2. If the dispenser is newly installed, check the water connections for use of plumbers putty or sealant. Sealants do not need to be used and may affect the taste and odor of the water. Clean off the sealant, reattach the connections, and let the water run to refresh the water in the tank.
Installation Help - InSinkErator
Find the answer to your question. Search. Home
Faucet Leaks or Drips - InSinkErator
If water is dripping or leaking from your faucet, find out how to resolve the issue. Written Directions Before attempting to repair your hot water product, read and understand the entire InSinkErator safety and installation instructions listed below.
InSinkErator Register a Product
Thank you for purchasing an InSinkErator ® product! Your registration benefits include: Faster service & support • Special promotions • Safety & recall notifications
Water or Steam Spitting from Spout - InSinkErator
Locate the thermostat dial on the front of the tank and turn it 1/2 a notch counterclockwise to decrease the temperature. Depress or twist the dispenser handle for 20 seconds to allow cold water to enter the tank. Allow the water to reheat to the new setting. Continue adjusting the dial in small increments until the temperature is to your liking.
Dispenser Makes Rumbling or Gurgling Sound - InSinkErator
1. If the water temperature in your tank is set too high, it may make a louder rumbling or gurgling noise when heating the water. To adjust the thermostat, look at the tank using a flashlight, if needed. Locate the thermostat dial on the front of the tank and turn it 1/2 a notch counterclockwise to decrease the temperature.
Dispensers - support.insinkerator.com
Dispenser Makes Rumbling or Gurgling Sound. Faucet Leaks or Drips. How to Clean & Disinfect a Faucet. Water Taste or Odor. Water or Steam Spitting from Spout. No Hot Water. Water Too Hot or Not Hot Enough. Installing an Instant Hot Water Dispenser