RR Ridge Rafter Connector - Simpson Strong-Tie
For a rafter-to-face connector, flatten the top flange into the face plane. The RR may be used with rafters sloped up to 30°. A catalog including new product information as well as any applicable specification and installation instructions for wood-to-wood …
How to Connect Rafters to Ridge Beam | 11 Easy Guides (2024)
2024年3月9日 · 9 Tips for Connecting Rafters to Ridge Beam: Place the ridge beam on top of the rafters. Align the rafters so that they are flush with the ends of the ridge beam. Drill pilot holes through the rafters and into the ridge beam. Secure the rafters to the ridge beam using bolts or screws. Trusses can also be used to connect rafters to a ridge beam.
How to connect rafters to ridge beam - Fine Homebuilding
2005年8月16日 · > Tip for connecting rafters to ridge beam: toe nail the rafters in first, then come back and install your Simpson brackets. You will get a more even roof deck that way. That'll work with hangers and A-35's and a lot of Simpson stuff, but alas, not with the RR's. They go between the rafters and the ridge.
RR Galvanized Ridge Rafter Connector for 2x6 Nominal Lumber
Simpson Strong-Tie offers a diverse line of hangers to handle almost any application with top flange, concealed flange and field-skewable and slopeable options. The RR ridge rafter connector provides a connection between a rafter and the ridge of a roof.
Rafter to Ridge connection - InterNACHI®️ Forum
2006年8月22日 · Rafters connected to a ridge board rely on being directly accross from one another to help support the ridge of the roof. Rafters that are offset from one another can cause undo stress on the ridge board itself being that there is no rafter opposite it.
Do I need to address a gap between rafter and ridge board?
2023年12月18日 · There's shear loading on the fasteners bridging the slip plane between the ridge and the rafters. As a gap widens at the slip plane, the fastener strength goes down. For the set of rafters without collar ties, each rafter rotates around a …
LRUZ Face-Mount Rafter Hanger - Simpson Strong-Tie
The LRUZ offers an economic alternative for those applications requiring a sloped hanger for rafter-to-ridge connections. Used with solid sawn rafters, the LRUZ’s unique design enables the hanger to be installed either before or after the rafter is in place.
How to Install Ridge Board & Rafters | ehow
Check the ridge board to make sure it is level and the end rafters are still plumb, then add a second nail to each birdsmouth and ridge board connection. Make sure the splice will fall between two rafter pairs, so each end is fully supported by rafters.
RR47 Ridge Rafter Connector - Strong-Tie
The RR47 Ridge Rafter Connector provides a solid connection between rafter and ridge beam. The RR47 provides alignment control and correct nailing locations. Please check the Corrosion Information to see if it is suitable for your application.
Ridge Rafter Connector - RR | Simpson Strong-Tie
The RR ridge rafter connector provides alignment control and correct nailing locations. The RR may be used with any rafter slope up to 30°. For back-to-back installations, the minimum width of the ridge plate is 38mm.